We use this to find leaks that soap bubbles miss. It sniffs the air around every joint and fitting and alerts us to the presence of gas, even at low concentrations.
Gas line repair St. Paul MN done right the first time
When you need gas line repair St. Paul MN homeowners trust, we handle everything from leak detection to full gas line installation St. Paul. If you smell gas or your line fails inspection, call us at +16513720726 and we will make it safe.
Serving St. Paul and nearby areas.
How big is the gas line job?
Section replacement
A run of pipe behind a wall or under a floor, plus a new appliance hookup.
- 1. Single fitting One leaking joint or valve, accessible in an open basement or utility room.
- 2. Section replacement A run of pipe behind a wall or under a floor, plus a new appliance hookup.
- 3. Full line Main gas run replacement or a new line to a garage or addition.
Drag the needle to compareTouch and drag the needle
- 19Services from one local team
- 16Areas served around St. Paul
- Detect firstWe find the leak before we cut
- Test twicePressure test before and after
What our gas line service covers
Every gas line repair or installation includes a full inspection, a pressure test, and a written record of what we found and what we did.
Work order
Gas Line Repair and Installation- Full line inspection: We walk the entire gas run from the meter to every appliance. Every joint gets checked with a combustible gas detector and soap solution. We note pipe material, size, and condition so you know what you have.
- Leak detection and repair: If we find a leak, we isolate it, cut out the failed section with a pipe cutter, and replace it with new copper pipe or PEX tubing. We use SharkBite fittings or soldered joints depending on the application and code requirements.
- Pressure test and documentation: After any repair or install, we cap the line, pressurize to 10 PSI, and watch the gauge for 30 minutes. You get a copy of the test results. If the gauge moves, we keep working until it holds.
- Permit pulling and inspection: New gas line installations and most replacements require a permit in St. Paul. We pull it, schedule the inspection, and meet the inspector on site. You get the signed-off paperwork for your records and your insurance company.
- Appliance reconnection and testing: After the gas line passes, we reconnect your range, dryer, furnace, or water heater. We relight pilots, check burner flames, and confirm the appliance runs correctly before we leave. No loose ends.
What the first visit covers
First visit
We inspect the full gas run, test every joint, and give you a written scope with a price before any work begins.
Gas lines at St. Paul homes
We handle gas lines for furnaces, ranges, dryers, fireplaces, and water heaters.
Furnace hookup
New line or repair for gas furnaces and boilers.
Range and dryer
Install or replace lines for kitchen and laundry appliances.
Water heater
Gas connector and shutoff valve for tank or tankless units.
Garage heater
Run a line to a detached or attached garage heater.
Gas lines at St. Paul businesses
We work with property managers and business owners on commercial gas lines.
Restaurant kitchens
Gas lines for ranges, fryers, and ovens.
Multi-family buildings
Main line repairs and appliance hookups.
Retail and office
Gas lines for rooftop units and heaters.
Gas line repair St. Paul MN: what the work involves
Gas lines are not a place to guess. We find the problem, fix it to code, and test it before we leave. That is how you keep a St. Paul home safe.
Gas line repair St. We pressure-test every line after repair, check joints with leak detection equipment, and confirm the system holds steady before we sign off. Whether you have a pinhole leak in a copper run or a corroded fitting behind a furnace, the goal is the same: a code-correct line that passes inspection and keeps your family safe.
St. Paul homes take a beating from freeze-thaw cycles, and older properties in Frogtown and Dayton's Bluff often still have original black steel or copper gas lines that have been patched over the decades. When a homeowner calls us for gas line repair near me St. Paul MN, the most common culprits are corroded fittings, shifted pipe from foundation movement, and appliance upgrades that outgrew the original line size. We see it every winter.
- When it helps
- You smell gas, a line fails inspection, or you add an appliance.
- What you get
- A pressure-tested line and a signed-off permit.
How our gas line service works
From the first phone call to the final pressure test, here is exactly what happens when you hire us for gas line services St. Paul.
Tools and methods we use on gas lines
Each method answers a different question. Together they leave very little to guess.
For clean cuts and leak-free soldered joints on copper pipe. We also carry SharkBite fittings for PEX and copper push connections where code allows.
Used for PEX tubing connections. PEX is flexible and corrosion-resistant, which makes it a good choice for certain gas line runs where code permits its use.
We cap the line, pressurize to 10 PSI, and watch the gauge for 30 minutes. If it holds, the line passes. If it moves, we keep working until it does not.
For hidden lines behind walls or under slabs, we use electronic detection tools to trace the run and pinpoint the leak without tearing up the whole house.
When St. Paul homeowners call us for gas lines
You are converting from an electric range to a gas range and need a new line run from the meter.
We size the line for the range BTU load, run copper pipe or PEX tubing from the nearest gas source, and install…
HomesYour furnace will not stay lit and the HVAC tech says the gas line is the problem.
We test the gas supply at the furnace with a manometer to confirm pressure.
HomesYou smell gas in the basement and the utility company red-tagged your meter.
We treat it as an emergency.
HomesYou are finishing a basement and need a gas line run to a new fireplace or garage heater.
We plan the route to minimize wall opening, run the new line in copper or PEX, and install a shutoff valve at…
Homes
How gas line work runs in St. Paul
St. Paul gas line work is shaped by the city's housing stock and its climate. Homes in Summit Hill and Macalester-Groveland were often built between 1910 and 1940, and many still have original black steel gas lines that have been patched repeatedly.
Summit Hill
Many homes here have original gas lines running through finished basements. We plan routes to minimize wall opening and protect historic trim.
Frogtown
A mix of older homes and newer construction. We see undersized lines from past DIY upgrades and often need to replace the whole run.
Highland Park
Post-war ramblers with gas lines in crawlspaces. Access is tight, so we use flexible PEX tubing where code allows to avoid cutting into floors.
- Summit Hill
- Frogtown
- Highland Park
- Downtown St. Paul
- Battle Creek
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoCorroded fitting replaced in Highland Park
Before: A homeowner smelled gas near the furnace. The black steel line had a corroded elbow fitting that was leaking slowly. The line had been patched twice before by a previous owner.
After: We cut out the corroded section, replaced it with new black steel pipe and fittings, and pressure-tested at 10 PSI for 30 minutes. The gauge held steady. The homeowner passed inspection the next day.
New gas line for a tankless water heater
Before: A homeowner in Como Park installed a tankless water heater but the existing half-inch gas line could not supply enough BTUs. The unit kept shutting off mid-cycle.
After: We ran a new three-quarter-inch copper line from the meter to the water heater, installed a dedicated shutoff valve, and pressure-tested the run. The tankless unit now runs continuously without shutting off.
Emergency gas leak repair in Dayton's Bluff
Before: A property manager called after a tenant reported a gas smell in the basement. Xcel Energy red-tagged the meter. The building had no gas service and tenants had no heat.
After: We found a cracked fitting on the main gas run, replaced it, and pressure-tested the entire line. The test held at 10 PSI for 30 minutes. Xcel restored service the same day and tenants had heat by evening.
Gas line problems we fix in St. Paul
Most gas line calls fall into a few categories. Here is what we see most often and how we handle it.
Corroded fittings on older black steel lines
A corroded fitting can leak slowly for months before you smell it. We cut out the corroded section and replace it with new pipe and fittings.
Undersized gas line for a new appliance
A line that is too small starves the appliance.
Gas smell with no obvious source
A faint gas smell that comes and goes is often a pinhole leak in a hidden line. Ignoring it is dangerous.
Failed inspection after a DIY gas line install
Unpermitted or incorrect gas work fails inspection and can void your homeowner's insurance. If you are selling the house, it can kill the deal.
Why St. Paul homeowners call us for gas lines
Gas work is not a DIY job. One wrong fitting and you have a leak you cannot see or smell until it is dangerous.
Licensed and code-correct
Every gas line installation services St. Paul job we run is permitted and inspected under the Minnesota Plumbing Code.
Same-day leak response
If you smell gas, call us at +16513720726. We prioritize gas leak repair St.
Appliance-ready installs
Adding a gas range, dryer, or tankless water heater?
Upfront pricing, no surprises
We quote the job before we start. Typical gas line repair cost in St.
What gas line work costs in St. Paul
Gas line pricing depends on access, pipe material, and how much line needs to be replaced or installed. Typical 2026 pricing in St.
Included
Quoted after a first look
- Full line inspection
- Leak detection and repair
- Pressure test and documentation
- Permit pulling and inspection
What changes the scope
Quoted after a first look
- Access to the line
- Pipe material
- Length of the run
- Permit and inspection fees
What you get on a gas line job
Clear records you can keep and share.
Test results
A copy of the 10 PSI pressure test.
Permit sign-off
The inspection paperwork for your records.
Written scope
What we found and what we did.
Local gas line experience you can verify
We work to the Minnesota Plumbing Code on every job and follow OSHA safety compliance on every site.
Gauge reading
We watch the pressure gauge for 30 minutes. If it holds at 10 PSI, the line is sound.
Pipe condition
We check for corrosion, cracks, and loose fittings. Old black steel often fails from the inside.
BTU load
We calculate the demand of every appliance on the run. That tells us what pipe size you need.
Is your St. Paul neighborhood covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
St. Paul ZIP codes
- 55114
- 55117
- 55116
- 55119
- 55130
- 55101
- 55155
- 55102
- 55103
- 55106
- 55107
- 55104
- 55105
- 55108
Towns we serve.
Based in St. Paul and covering the places around it. Pick one for local details.
What St. Paul customers say
We smelled gas near the furnace and called at 7 a.m. A tech was here by 8:30. He found a corroded fitting on the old black steel line, replaced it with new pipe, and pressure-tested the whole run. He showed me the gauge holding at 10 PSI for 30 minutes. Fair price, no mess left behind. I will use them again.
We were adding a gas dryer and the old line was too small. They ran a new copper line from the meter, pulled the permit, and met the inspector. Took about four hours total. The tech explained the BTU sizing so I actually understood why the old line would not work. Clean work, fair price.
We manage a small commercial building and needed a gas line inspection for a tenant buildout. They showed up on time, tested every joint, and gave us a written report with photos. The inspector signed off the same week. Professional and easy to schedule. We will use them for our next project.
Gas line questions St. Paul homeowners ask
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
+16513720726Most gas line repairs in St. A simple fitting swap behind an appliance sits at the low end. A buried line or one inside a finished wall costs more because we have to open and close the surface. We quote the price before we start, so you know the number up front.
The clearest signs are a rotten-egg smell, hissing near a gas line, dead grass over a buried line, or a higher-than-normal gas bill. Some people get headaches or nausea in one room. If you notice any of these, leave the house and call 911 or Xcel Energy first, then call us at +16513720726 for gas leak detection and repair St. Paul MN.
Yes. We install new gas lines for ranges, dryers, fireplaces, garage heaters, and tankless water heaters. We size the line for the appliance BTU load, pull the permit, and pressure-test at 10 PSI for 30 minutes before sign-off. Most single-appliance new gas line installation in St. Paul Minnesota takes three to five hours.
A single-appliance gas line installation usually takes three to five hours, including the pressure test. A full replacement of a main gas run through a basement or crawlspace can take one to two days. If we are running a new line to a detached garage or addition, plan on a full day plus the inspection window.
Other plumbing services we handle
Other services from the same team.
Need gas line repair St. Paul MN today?
+16513720726If you smell gas, leave the house and call 911 first. Then call us at +16513720726. Paul and Ramsey County, and we prioritize gas leak calls. Same-day windows are usually available.
Contact our St. Paul plumbers
Call us at +1 651-372-0726 for service, estimates, or emergency repairs. You can also email [email protected] and we will get back to you within one business day.